Label Set-Jackall Tank

H845
Required Qty 1
ex Shipping gms
Add to cart
Request a quote
  • Description
  • More

  • Y Series

H845 Fitting Instructions

 

Make sure surface is clean, dry and free from grease. It is recommended unit is removed and re-painted first, to eliminate any show-through of old transfers. Cut around each transfer leaving roughly a 6mm or 1/4” margin.

 

This is a waterslide transfer.

 

  1. Dip in water for approximately 30 seconds.
  2. After one minute, slide the transfer just beyond the edge of the paper.
  3. Place on the article where it is to be fixed, and whilst holding the edge of the transfer, gently pull the paper from underneath.
  4. Place paper (same side towards you) on top of the transfer and rub down with flat of hand whilst holding the paper.
  5. Peel off paper and leave to dry.
  6. After the transfer is dry remember to pierce centre air vent hole in cap.